banner



How To Install Halo Fog Lights

3 Means to Install LED Angel Optics Halo Rings For Fog Light Retrofit

This installation guide volition prove you a few means you lot tin can install the 40-SMD LED angel eyes halo rings (AA1118) made for retrofit use. The LED angel eyes halo rings is a very versatile piece of LED lighting that cane be installed in many ways. Measured at eighty millimeters or 3.15 inches, it can fit over fog lights that are 2.5 to 3.five inches. Because this is a highly retrofitted item, y'all will have to make modifications such every bit cutting, gluing, and drilling to install the LED halo rings. Please brand sure to test the LED rings to run across if they light up before making these modifications.

Ultra Blue, White, or Red 40-SMD LED Angel Eyes Halo Rings w/ Chrome Shrouds For Fog Lights Custom Retrofit DIY Use

Here are 3 ways that you tin alter to install your LED angel eyes:

Cutting Holes in Your Fog Light Housing

This method of modifying is recommended for use with smaller projector foglights. Cut holes on the side of the fog lite housing then that the shroud tin fit over your fog lights. Make sure the distance between the holes are the same equally the distance between the tabs on the shroud of the LED angel eyes. Insert the LED halo ring with shroud over your existing fog lite. The shroud should fit snug over your fog low-cal housing.

Cut Off The Tabs

This kind of alteration is best used for bigger fog lights. Cut off both tabs entirely to allow the inner ring circled in red to exist the holding signal. Apply glue to the inner ring and secure it over your fog low-cal housing.

Removing The Shroud

This style of adapting is the to the lowest degree painless as it does not involve cut, drilling, or whatever other method of hard modding. Simply pop off the LED angel middle from the shroud. Use double-sided tape or glue to secure the halo ring over your fog lights.

Subsequently installing your LED affections eyes halo rings, connect the ii wires to either your existing parking light harness, or your fog light harness'due south positive (+) and negative (-) wires.

These approaches to installing the retrofit LED affections eyes halo rings is just three of many different ways of modifying; yous are limited only by your imagination. How will y'all retrofit your LED halo rings?

Source: https://store.ijdmtoy.com/pages/3-ways-to-install-led-angel-eyes-halo-rings-for-fog-light-retrofit

Posted by: hillcating.blogspot.com

0 Response to "How To Install Halo Fog Lights"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel